Remove any recently added internal hardware. and the automatic startup repair is NOT helping :) Thank you for your time Reports: · Posted 5 years ago Top GuiltySpark Posts: 4024 This post has been reported. Check that the data on the discs are good. Also I can get into recovery option where I can access command prompt... http://phpbbinstallers.net/not-working/recovery-cd-no-2-is-not-working.html
These are not the correct recovery discs. Figure : Choose an option On the Troubleshoot screen, click Recovery Manager. note: More than one CD/DVD drive selection might be available from the list of bootable devices. Also, on rare occasions, this error can occur when data on the hard drive was not configured correctly at the factory. http://support.hp.com/us-en/document/c01868346
note: If this error occurs with recovery discs created from the same computer, or from discs that were sent by HP, contact HP to receive a replacement set. Best answer dodger46May 7, 2014, 12:14 PM If you have an HDD perhaps try installing windows to that in order to prove SSD defective. Disconnect all connected devices and cables such as Personal Media Drives, USB drives, printers, and faxes. This can occur depending on the type and size of the AF drive and with recovery discs created prior to Fall 2010.
boot up the system repair disc, go to a command prompt and use diskpart. note: Do not disconnect the monitor, keyboard, mouse, or power cord. The motherboard on your computer was replaced with a motherboard that is not the same replacement part. Hp Recovery Manager Not Working Windows 10 Preview post Submit post Cancel post You are reporting the following post: Recovery and/or factory reinstall disc not working disc 2 This post has been flagged and will be reviewed by
note: Do not disconnect the monitor, keyboard, mouse, or power cord. To obtain recovery discs, see the HP support document Looking for HP Recovery Discs or an HP USB Recovery Drive. If the error persists, continue using these steps. Thread Status: Not open for further replies.
Recovery Manager stops responding and displays the error code: Error 1002 To resolve the error, follow these steps: After the error message displays, turn off the computer. Ubuntu Boot Cd Make sure the recovery discs are clean and scratch-free before attempting a recovery. This can occur depending on the type and size of the AF drive and with recovery discs created prior to Fall 2010. To resolve the error, follow these steps: After the error message displays, turn off the computer.
Insert a different disc that has not already been used until the message stops and the recovery process continues. http://phpbbinstallers.net/not-working/refresh-recovery-not-working.html It could not see any sort of hard drive. Figure : Operating system selection screen Under I need help immediately, click System Recovery. If you are still able to use Windows, use the Hardware Diagnostic Tools to diagnose the problem. Hp Recovery Manager Not Working Windows 8
Turn off the computer by pressing and holding the power button. Windows 10 Recovery Not Working If so, select one of the CD/DVD selections from the list to see if HP Recovery starts. If you have tried recovering at least two more times, and the recovery process continues to fail at the same point, replace the recovery discs or service the computer to replace
Dolkie, Jun 8, 2009 #6 Megabite Joined: Apr 5, 2008 Messages: 11,761 On my Toshiba I had to press and hold F1 for it to work Megabite, Jun 8, 2009 Advertisement Dolkie Thread Starter Joined: Jan 21, 2009 Messages: 5 Hi, first post, I have been trying to restore my Asus G2sg-A1 laptop to its original state by using the Recovery Otherwise if you have more than one stick of RAM try running on one at a time to eliminate them from enquiries... Windows 7 Startup Repair Not Working Is your bios set to boot from your DVD drive first?
Also, on rare occasions, this error can occur when data on the hard drive was not configured correctly at the factory. To buy recovery discs, see Obtaining HP Recovery Discs or an HP USB Recovery Drive. A "Cannot extract the archive" message displays The following error message appears while recovering the computer from recovery discs: Cannot extract the archive. check over here If you're new to Tech Support Guy, we highly recommend that you visit our Guide for New Members.
If an error opens or the file transfer process stops responding, the data on the disc is corrupted and you need to replace the discs. You then Power On you computer. Then press Enter. Join over 733,556 other people just like you!
From the Start screen, type recovery to open the Search charm, and then select HP Recovery Manager from the search results. To test the hard disk drive, refer to Testing a Hard Disk from the BIOS.